pro.point 8345381, Руководство пользователя

Страница: 11 / 24

Fluxchipper and Needle Scaler Kit
11
For technical questions call: 1-800-665-8685
8345381 V 1.01
TROUBLE SHOOTING
Problem(s) Possible cause(s) Suggested solution(s)
Tool runs at normal speed
but loses power under load.
Piston parts worn.
Have a qualified technician
replace worn parts.
Lack of air tool oil.
Pour air tool oil into air inlet per
instructions.
Tool runs slowly.
Air flows slightly from exhaust.
Piston parts jammed with dirt particles.
1. Check air inlet filter for blockage.
2. Pour air tool oil into air inlet as per
instructions.
3. Operate tool in short bursts quickly
reversing rotation back and forth
where applicable.
4. Disconnect supply. Free motor by
rotating drive shank manually
where applicable
5. Repeat above as needed. If this fails,
bring to service center.
Air flow blocked by dirt.
Excessive air tool oil in tool
or build of shipping grease.
Run tool under no load for short periods of
time until exhaust clears.
Tools will not run.
Air flows freely from exhaust.
O-rings throttle valve dislodged
from seat inlet valve.
Have a qualified technician
replace the O-ring.
Damage to, or excessive wearing
of internal parts
Bring to service centre
Tool will not shut off.
O-rings throttle valve dislodged
from seat inlet valve.
Have a qualified technician
replace the O-ring.
Loss of power or erratic performance.
Excessive drain on the air line. Moisture or
restriction in the air hose. Incorrect size or
type of hose connectors.
Check the air supply. Ensure tool is
connected to a 3/8” I.D. or larger air
hose with no kinks or restrictions and that
the fittings are connected properly.
Air compressor has insufficient flow.
Ensure tool is connected to a compressor
whose rated flow matches the tool.
Note: Repairs should be carried out by a qualified person