Pro-Peak Sigma EQ Hyper, Руководство по эксплуатации

Страница: 12 / 56

- 12 - - 13 -
When the battery is in the process of being charged and
discharged it can often become warm after the charge or
discharge period. The program can insert a time delay to
occur after each charge and discharge process to allow the
battery adequate time to cool down before being subjected to
the next process. The value ranges from 1 to 60 minutes.
The trickle charge mode can be set to either on or off. If it
is set to on, the charger will automatically supply the trickle
charge current to achieve the full charge without overheating
the battery after the fast charge has been terminated.
When the charge process is started, the integral safety
timer automatically starts running at the same time. This
is programmed to prevent overcharging the battery. If the
battery is faulty or if the termination circuit cannot detect that
the battery is full, the value for the safety timer should be
generous enough to allow a full charge of the battery.
This program sets the maximum charge capacity that will
be supplied to the battery during charge. If the delta-peak
voltage is not detected or the safety timer has expired for any
reason, this feature will automatically stop the process at the
selected capacity value.
Initial Parameter Set Up (User Set Program- Continued)
Waste time
CHG/DCHG 5min
NiMH/NiCd/Pb
Trickle 100mA
Safety timer
ON 120min
Input power low
Cut-off 10.0V
Key Beep ON
Buzzer
ON
Back-Light
100%
DEC INC
DEC DEC
DEC
INC INC
INC
DEC INC DEC INC
DEC INC DEC INC
DEC INC
DEC INC DEC INC
DEC INC
Capacity Cut-Off
ON 5000mAh
The beep sounds every time the buttons are pressed to
confirm your action. The beep or melody sounds at various
times during operation are to alert you to different mode
changes. These audible sounds can be on or off.
This program monitors the voltage of the input DC battery.
If the voltage drops below the set value, the operation will
forcibly terminate in order to protect the input battery.
The brightness of the LCD screen can be adjusted during
the charge process.
DEC INC
DEC INC
DEC INC
DEC INC
DEC INC