18
Configure IP Address Manually
:
c)
Select “
Use the following IP address
” and “
Use the following DNS server addresses
”.
IP address
: Fill in IP address 192.168.1.x (x is a number between 2 to 254).
Subnet mask
: Default value is 255.255.255.0.
Default gateway
: Default value is 192.168.1.1.
Preferred DNS server
: Fill in preferred DNS server IP address.
Alternate DNS server
: Fill in alternate DNS server IP address.
Θ!
If you decide to use IP address from Wireless Router, select
“Obtain an IP address
automatically”
.
Θ!
If you decide to use the IP address you are desired, select
“Use the following IP
address”
. Make sure enter correct addresses in
“IP Address”
and
“Subnet Mask”
fields.
Θ!
You must set Wireless Router’s IP address as
“Default Gateway”
.
Θ!
If the DNS Server fields are empty, select
“Use the following DNS server addresses”
and enter the DNS address is provided by your ISP, then click
“OK”
.
You can use ping command under DOS prompt to check if you have setup TCP/IP protocol
correctly and if your computer has successfully connected to this router.
1) Type
ping 192.168.1.1
under DOS prompt and the following messages will appear:
