•
To operate the courtesy light - Pr
white courtesy light. When you pre
will be turned off and the red courte
switch a 3
ess the switch labeled courtesy once to turn on the
ss the same switch a 2
nd
time, the white courtesy light
sy light (for night vision) will turn on. Press the same
ourtesy light.
e spreader light switch operates in the same manor as
be pressed in once to be turned on and once again to
Com a
The co
console
the av
ligh
s
back to
rd
time to turn off the red c
•
To operate the spreader lights - Th
the courtesy light but only needs to
be turned off.
Instrumentation
p ss
mpass on the 25 Walk is located on the dash on top of the
. To ensure that the compass light is working properly, press
. lights switch in the forward position to turn on t
N
he red LED
t in ide the compass. When finished, turn the Nav. lights switch
the middle/off position.
lease refer to the ow
P
ner’s manual provided by the manufacturer of the compass for operational
and for information related to the care and maintenance of their product. When in doubt,
endations.
cated just aft of the bow pulpit.
Depress the horn switch to the up or forward position to activate the horn, then release the horn switch to
deactivate the horn. The horn is used to signal, warn or alert other boats or persons on shore. Using
different sequences of horn blasts indicates different and sometimes dangerous situations to you or
omeone around you.
red in a safe boating
ourse.
ll gauges are installed on the console but the configuration and specific location of your gauges will vary
ht up only when the engine is on.
For boats rigged with digital gauges, the
temperature, trim, volts and fuel gauges are incorporated into the tachometer gauge.
procedures
always defer to the compass manufacturer’s instructions and/or recomm
Horn
The horn switch is located on the switch panel and the horn device is lo
s
See the Safety section in this manual for more information. Avoid any horn use without an appropriate
purpose. Additional information regarding audible warning signals should be cove
c
Full Instrumentation / Gauges (Digital Except Suzuki)
A
depending upon the sel ection of the various optional engine packages. If your engine package includes
analog gauges (i.e., Faria), the gauges will light up when the navigation lights are on. If your engine
package includes digital gauges provided by the engine manufacturer (i.e., Mercury SmartCraft, Honda,
etc.), the gauges will lig
Note: For boats rigged with analog gauges (i.e., Faria), the gauge configuration may
include individual gauges for temperature, trim, volts and fuel gauges or a multifunction
gauge that includes these 4 gauge functions.
Tachometer
The tachometer (tach) gauges are located on the console. To ensure the tach is working properly, simply
turn the ignition key on and start the engine. While the engine is idling, the tach should be reading in the
proper RPM range recommended for the engine. Your engine manual will indicate the appropriate RPM
range. When you are running at wide-open throttle, the tach should read near the top end of the
commended RPM range.
re
21
