
Cockpit / Deck Drains
There are three (3) cockpit/deck drains in the aft area of the cockpit that
allow excess water in the cockpit to drain overboard via thru hulls on each
side of the boat. To ensure that there is no blockage in any of the hoses
connected to the drains, it is recommended that you occasionally run
water through each of the cockpit drains and visually inspect the thru hulls
to verify that water flows freely and that there is no blockage. To trouble
shoot, check the hoses for leaks and make certain that all hose
connections are secure.
Drain Plug
Before launching the boat, always make sure that the drain plug has been installed in the fitting on the
transom at the keel. If your boat is being transported, remove the drain plug once the boat is secured on
the trailer so that any excess water can be drained via the fitting. Never remove the drain plug when the
boat is sitting static in the water.
If you live in an area where it snows and you are storing your boat on a lift during the winter, make sure
that you remove the drain plug. When the snow melts, if the float switch for the bilge pump happens to
fail, it could flood the bilge and damage electrical components in the bilge.
Rigid T-Top with Storage Box (Optional)
The anodized aluminum frame comes with a rigid top and built in storage box. A set of 4 rod holders is
permanently mounted to the aft edge of the frame; providing you with additional rod holder capacity. See
the Service and Care section of this manual for cleaning recommendations for the anodized aluminum
frame and the rigid top.
Set of 4 Rod
Holders
Life Jacket
Pouch
Overhead
Storage Box
Note: Pro-Line installs mounting pads to the frame for additional support when outriggers
are factory installed. Before adding after market outriggers, we recommend that you
consult your Pro-Line dealer’s Service Department or another qualified service
professional to add mounting pads to the T-Top frame
Rigid T-Top with Storage Box & Outriggers (Optional)
When factory installed, this options includes the same frame and storage box as above. However, with
the installation of the outriggers, we have included mounting pads for additional support.
When this option is selected and factory installed, the outrigger installation includes a pair of outrigger
bases, poles and lines. The bases are constructed of anodized aluminum and are installed on the port
32