9
from 0 to 9 (high sensitivity level) by using digital buttons 0-9.
Press “
START
” button to enter a new figure in the data store and exit sensitivity level
change mode.
Technical maintenance
In order to provide the best functioning of the device, it is necessary to comply with the
following simple requirements:
Switch off the device, when not in use
Use protective cover, when not in use
Clean the hopper and stacker with a clean dry cloth. Sensors can cause errors when
dirty. It is recommended to carry out preventive measures, including partial disassem-
bling of the counter each 30 days by an engineer in the service center.
Error codes
Press "
START
" button to clear error message and continue counting procedure.
Error Code
Ursache
Fehlerbeseitigung
F-1
1. Passing of halved
banknote
2. Failure of left or right
sensors of the counter
1. Remove the banknotes from the stacker
and take away the suspicious banknote (lying
on the top). Repeat the counting procedure
1. Contact appropriate
dd
Chain note detected
Remove banknotes from the feed opening,
and repeat counting procedure.
Ed
Double notes detected, notes
are stuck together
1. Remove the banknotes from the hopper
and press “START” button to continue
counting procedure
2. Adjust the slot, see Table 8.1.
Eu
Suspicious note detected by
UV
Remove the suspicious banknote (lying on the
top), and press “START” button to continue
counting procedure. Use additional verification
methods for suspicious banknote
En
Suspected note without
magnetic marks detected
Remove the suspicious banknote (lying on the
top), and press “START” button to continue
counting procedure. Use additional verification
methods for the suspicious banknote.
Remember that detection is designed for
EURO and USD only.
