4
-continues counting and clears error messages on display 2
-clearing counting result on the main display 1
-storing changes to the counter settings
4. “ADD” button
ON/OFF summation mode. Pressing the button once switches ON the summation mode
(indicator lights up). Pressing the button a second time switches OFF the mode.
5. “UV” button
Switch ON/OFF UV detection (by default indicator is ON)
6. “E$” button
Switch ON/OFF magnetic detection for EURO and USD (by default indicator is ON).
7. Digit buttons (0-9)
Used for entering number values on display 2 in batch mode (counting of specified
number of banknotes). Press any digit button (from 0-9) to enter batch mode
automatically.
8. “MUL” button
Automatic/manual counting mode. To start calculations in manual mode it is necessary
to press “
START
” button. In automatic mode (indicator is off by default) counting starts
automatically after you place a stack of banknotes in the hopper.
9. “CLR” button
This button clears the figures on display 1 and 2.
After pressing the button, the device quits batch mode and resets the summation and
counting results.
10. “SP” button
The “
SP
” button changes the counting speed. Each pressing of “
SP
” button changes the
speed. The display will depict the current speed value. After pressing “
START
” button,
the counter will save the set speed value and uses it in the future.
5
Safety precautions and maintenance rules
• Read this manual before operation
The manual should be available to operator.
• The device should be installed on an even horizontal surface, away from water and
dangerous objects
• Don’t place the device in an area where it can be affected by direct sunlight, direction-
al artificial light, strong vibration, or dust
• Do not operate the device with wet hands
• Do not expose to water (or other liquid). Avoid foreign objects
• Avoid dropping the device
• During operation:
When finished be sure there are no banknotes in the hopper or transport system
Figure 2
• Clean the device regularly and service the device as needed at a licensed service cen-
ter to comply with the specified parameters
• Do not disassemble, repair or attempt to update the counter on your own. This can
