6
7
4. Refer to the inset drawing. Remove the rubber
bands from the Bracket Screws (32) in the left side
of the Base (1). Make sure that the Arm Brackets
(31) inside the tubes are pressed against the indicat-
ed sides of the tubes.
Align the posts on the Left Armrest (6) with the tubes
on the Base (1). Slide the Left Armrest onto the
Base.
Make sure that the posts are inside of the
tubes on the Base. Note: You may need to flex
the posts away from the Left Side Shield (8) to
slide the Left Armrest past the Bracket Screws
(32).
Attach the Pillow (13) to the fastener strip.
5. Raise the footrest by pulling on the Footrest Control
Arm (23), shown in the inset drawing. Attach the
lower end of the Right Side Shield (7) to the right
side of the Base (1) with two Arm Cover Screws (35)
and two M6 Washers (95).
Attach the lower end of the Left Side Shield (not
shown) to the left side of the Base (1) in the same
way.
Using the included allen wrench, tighten the four
Bracket Screws (32) in the right side of the Base (1).
Tighten the four Bracket Screws (not shown) in the
left side of the Base (1).
6. Plug the cord from the Hand Control (22) into the
socket on the back of the massage chair.
Make sure
to align the indicated tabs.
5
1
31
32
32
31
1
8
6
32
13
32
32
35
7
1
22
Socket
Tabs
6
Note: For clarity,
some parts of the
chair are not shown
4
95
HOW TO PLUG IN THE POWER CORD
This product must be earthed.
If it should malfunc-
tion or break down, earthing provides a path of least
resistance for electric current to reduce the risk of
electric shock. Use this product with an equipment-
earthing conductor and an earthing plug. Plug one
end of the cord into the massage chair.
Plug the
power cord into an appropriate outlet that is prop-
erly installed and earthed in accordance with all
local codes and ordinances.
Use only a power cord type H05VV-F with a conductor
of at least 1mm
2
, with a country recognised plug and
an appliance coupler.
HOW TO TURN ON THE POWER
Make sure the power
switch on the back of the
chair is in the ÒonÓ position.
Next, press the power but-
ton on the hand control; an
indicator will light. Note: If
there is a thin sheet of
plastic on the face of the
hand control, remove it.
HOW TO TURN OFF THE POWER
To turn off the power, press the power button on the
hand control. The power indicator will darken. Return
the power switch on the back of the chair to the ÒoffÓ
position.
DANGER:
Improper connection of
the equipment-earthing conductor can result
in an increased risk of electric shock. Check
with a qualified electrician or serviceman if
you are in doubt as to whether the product is
properly grounded. Do not modify the plug
provided with the productÑif it will not fit the
outlet, have a proper outlet
installed by a qualified electrician.
How to Operate the Massage Chair
Power Button
FUSED
23
