7
3. Identify the Right Upright (79) and the Right
Upright Spacer (83), which are marked with
“Right” stickers. Insert the Upright Wire (86)
through the Right Upright Spacer as shown.
Then, set the Right Upright Spacer on the Base
(60).
Have a second person hold the Right Upright
(79) near the Base (60).
See the inset drawing.
Tie the wire tie in the Right Upright securely
around the end of the Upright Wire (86). Then,
pull the other end of the wire tie until the Upright
Wire is routed completely through the Right
Upright.
60
Wire Tie
86
79
83
86
3
2. Attach a Wheel (90) to the Base (60) with a 3/8"
x 2" Bolt (3) and a 3/8" Locknut (11).
Do not
overtighten the Locknut; the Wheel must
turn freely.
Press a Base Cap (85) into the Base (60).
See the inset drawing.
Cut the plastic tie near
the Wire Harness (86).
60
3
11
2
90
Wire
Tie
79
86
1.
Make sure that the power cord is unplugged.
With the help of a second person, carefully tip
the treadmill onto its left side. Partially fold the
Frame (53) so that the treadmill is more stable;
do not fully fold the Frame yet.
Cut the shipping tie securing the Upright Wire
(86) to the Base (60). Locate a tie in the indi-
cated hole in the Base, and use the tie to pull
the Upright Wire out of the hole.
Attach two Base Feet (88) to the Base (60) in the
locations shown with two #8 x 1" Tek Screws (2)
and two Base Foot Spacers (89). Then, attach
two Base Feet (88) with two #8 x 1" Tek Screws
(2).
1
60
2
53
2
2
88
88
2
86
88
88
89
89
Hole
85
Cut
86
