19
HOW TO TURN ON THE POWER
IMPORTANT: If the treadmill has been exposed to
cold temperatures, allow it to warm to room tem-
perature before you turn on the power. If you do
not do this, you may damage the console displays
or other electrical components.
Plug in the power cord (see
page 17). Next, locate the
power switch on the tread-
mill frame near the power
cord. Press the power
switch into the reset
position.
Next, stand on the foot rails of the treadmill. Find the
clip attached to the key and slide the clip onto the
waistband of your clothes. Then, insert the key into the
console. After a moment, the displays will light.
IMPORTANT: In
an emergency, the
key can be pulled
from the console,
causing the walk-
ing belt to slow to a
stop. Test the clip
by carefully taking
a few steps back-
ward; if the key is
not pulled from the
console, adjust the position of the clip.
IMPORTANT: Before you use the treadmill, take
the following steps to ensure that the console
shows the correct incline level of the treadmill:
First, press the Incline increase button once. Next,
press either the Incline decrease button or the low-
est Quick incline button to set the treadmill to its
lowest setting. When the frame stops moving, the
treadmill is ready for use.
HOW TO USE THE MANUAL MODE
1.
Insert the key into the console.
See HOW TO TURN ON THE POWER at the left.
2.
Select the manual mode.
Press the Manual Control button to select the
manual mode.
3. Enter your weight.
Press the Wt increase or decrease button to enter
your weight. This information will improve the accu-
racy of the power ring. Note: Press and hold the Wt
increase or decrease button to enter your weight
more quickly.
4. Start the walking belt.
To start the walking belt, press the Run button or
one of the Quick speed buttons.
If you press the Run button, the walking belt will
begin to move at 1 mph. As you exercise, change
the speed of the walking belt as desired by press-
ing the Speed increase and decrease buttons.
Each time you press one of the buttons, the speed
setting will change by 0.1 mph; if you hold down
the button, the speed setting will change in incre-
ments of 0.5 mph. Note: After you press the button,
it may take a moment for the walking belt to reach
the selected speed setting.
If you press one of the Quick speed buttons, the
walking belt will gradually change speed until it
reaches the selected speed setting. To select a
speed setting that includes a decimal—such as 3.5
mph—press two numbered buttons in succession.
For example, to select a speed setting of 3.5 mph,
press the 3 button and then immediately press the
5 button. Note: This option will not function if the
console is set to metric units.
To stop the walking belt, press the Stop button.
The time will begin to
fl
ash in the display. To restart
the walking belt, press the Run button or the Quick
speed buttons.
Reset
Key
Clip
Содержание performnce 600iPFTL79515.0
Страница 5: ...5 all STANDARD SERVICE PLANS...
