11
6
5.
Attach the Storage Latch (14) to the left Upright (11)
with two Latch Screws (101).
Be careful not to over-
tighten the Screws.
6.
Make sure that all parts are tightened before you
use the treadmill.
Keep the included allen wrench in a
secure location. The allen wrench is used to adjust the
walking belt (see page 13). To protect the floor or car-
pet, place a mat under the treadmill.
4.
The console requires three 1,5 V batteries
(included).
Alkaline batteries are recommended. To install batteries,
first touch one of the Handrails (1) to discharge any
static.
Next, open the battery cover as shown. Insert
three batteries into the battery compartment,
making
sure that the negative (Ð) ends of the batteries are
touching the springs in the battery compartment.
Close the battery cover, push up on the battery cover
tab, and then push the tab forward as shown in the far
right drawing. Be sure that the tab locks into place.
101
14
11
3.
Hold one of the Handrails (1) at an angle as shown and
insert the upper end as far as possible into the right
Upright (11). Keep the lower end of the Handrail away
from the treadmill to avoid scratching the finish. Next,
rotate the lower end of the Handrail to the position
shown by the dotted line.
Slide the other Handrail (1) into the left Upright (11) as
described above.
3a. With the help of a second person, carefully tip the
Uprights (11) down so the Extension Legs (34) are verti-
cal as shown.
Tighten a Handrail Bolt (74) with a Handrail Washer (75)
into the left Extension Leg (34) and the lower end of the
left Handrail (1) as shown. Note: To align the hole in the
Handrail with the hole in the Extension Leg, it may be
necessary to have a second person stand on the tread-
mill and lift the Handrail.
Next, tighten a Handrail Bolt (74) with a Handrail
Washer (75) into the right Extension Leg (34) and the
lower end of the right Handrail (1).
With the help of a second person, carefully raise the
Uprights (11) back to the vertical position.
11
11
34
1
1
3
75
74
1
34
34
11
3a
HOW TO LOWER THE TREADMILL FOR USE
1. Hold the upper end of the treadmill with your right hand as
shown. Using your left thumb, press the storage latch and
hold it. Pivot the treadmill until the frame and foot rail are
past the storage latch.
2. Hold the treadmill firmly with both hands, and lower the
treadmill to the floor.
To decrease the possibility of in-
jury, bend your legs and keep your back straight.
Storage
Latch
Unlatched
Battery
Cover
Battery
Cover Tab
Batteries
1
4
5
