8
BATTERY INSTALLATION
The console requires two or three "AA" batteries
(not included). Alkaline batteries are recommended.
Open the battery cover as shown in the drawing at the
upper right. Insert batteries into the battery compart-
ment, making sure that the negative (–) ends of the
batteries are touching the springs in the battery com-
partment.
Close the battery cover, push up on the battery cover
tab, and then push the tab forward as shown in the
inset drawing. Make sure that the tab locks into place.
STEP-BY-STEP CONSOLE OPERATION
Before operating the console, make sure that the
power cord is properly plugged in (see page 7).
Stand on the foot rails of the treadmill. Find the clip at-
tached to the key (see the drawing at the top of this
page), and slide the clip onto the waistband of your
clothes. Next, insert the key into the console. Test the
clip by carefully taking a few steps backward until
the key is pulled from the console. If the key is not
pulled from the console, adjust the position of the
clip as needed.
CAUTION:
Before operating the
console, read the following precautions.
• Do not stand on the walking belt when turn-
ing on the power.
• Always wear the clip (see the drawing
above) while using the treadmill. When the
key is removed from the console, the walk-
ing belt will stop.
• Adjust the speed in small increments.
• The training zones marked above the speed
control are general guidelines only. See
page 14 for more information.
• To reduce the possibility of electric shock,
keep the console dry. Avoid spilling liquids
on the console and use only a sealable
water bottle.
Tab
Batteries
Battery
Cover
Clip
Key
CONSOLE DIAGRAM
Note: If there is a sheet of clear
plastic on the console, remove it.
