10
8
8. Identify the Right Handlebar (10) and orient it as
shown.
Have a second person hold the Right Handlebar
(10) near the right side of the Upright (5).
Locate the indicated wire tie in the Upright (5).
Tie the lower end of the wire tie to the Pulse
Wire (34) inside the Right Handlebar (10). Next,
pull the upper end of the wire tie upward out of
the top of the Upright. Then, untie and discard
the wire tie.
Tip: Avoid pinching the Pulse Wire (34).
Attach the Right Handlebar (10) to the Upright
(5) with two M8 x 16mm Screws (102) and two
M8 Split Washers (103).
Attach the Left Handlebar (11) in the same way.
102
103
34
10
11
5
Wire Tie
Avoid pinching the
Pulse Wire (34)
9. Untie and discard the wire tie (not shown) on the
Wire Harness (60).
While a second person holds the Console (33)
near the Upright (5), connect the wires on the
Console to the Wire Harness (60) and to the
Pulse Wires (34).
Insert the excess wire into the Upright (5) or into
the Console (33).
Tip: Avoid pinching the wires.
Attach the
Console (33) to the Upright (5) with four M4 x
16mm Screws (93).
9
33
34
93
5
Avoid pinching
the wires
60