8
5.
See the upper drawing.
To avoid pinching or
damaging the Pulse Wires (28) while you
assemble the Handlebar (39), perform the fol-
lowing actions:
Insert the end of the left Pulse Wire (28) inside
the left side of the Handlebar (39).
Then, insert the end of the right Pulse Wire (28)
inside the right side of the Handlebar (39).
See the lower drawing.
Have a second person
hold the Handlebar (39) in place around the
Upright (2).
Tip: Avoid pinching the wires.
Attach the
Handlebar (39) to the Upright (2) with three M10
x 20mm Patch Screws (79).
39
39
79
79
28
28
Avoid pinching
the wires
5
2
6. The Console (4) can use four D batteries (not
included); alkaline batteries are recommended.
IMPORTANT: If the Console has been
exposed to cold temperatures, allow it to
warm to room temperature before inserting
batteries. Otherwise, you may damage the
console displays or other electronic compo-
nents.
Remove the screws, remove the battery
covers, insert the batteries into the battery com-
partments, and reattach the battery covers.
Make sure to orient the batteries as shown
by the diagrams inside the battery compart-
ments.
To purchase a power supply, call your local
Sears store. To avoid damaging the console,
use only a manufacturer-supplied power
supply.
Plug one end of the AC adapter into the
jack on the console; plug the other end into an
outlet installed in accordance with all local
codes and ordinances.
6
4
Batteries
Batteries
Screws
Battery
Covers
