23
Inspect and properly tighten all parts of the exercise
cycle regularly. The exercise cycle can be cleaned
with a soft, damp cloth. To prevent damage to the con-
sole, keep liquids away from the console and keep the
console out of direct sunlight.
TIGHTENING THE PEDALS
For best performance, regularly tighten both pedals.
CONSOLE TROUBLESHOOTING
If the console display becomes dim, the batteries
should be replaced. See assembly step 7 on page 9
for replacement instructions.
If the console does not display your heart rate when
you use the handgrip pulse sensor, see step 5 on
page 16.
HOW TO LEVEL THE EXERCISE CYCLE
If the exercise cycle
does not sit flat on
your floor, turn one
or both of the level-
ing feet until the
exercise cycle is
level.
HOW TO ADJUST THE BELT
If the pedals slip while you are pedaling, even while
the resistance is adjusted to the highest setting, the
belt may need to be adjusted. To adjust the belt, the
pedals and shields must first be removed. Using an
adjustable wrench, turn the right pedal counterclock-
wise and remove it. Then, turn the left pedal clockwise
and remove it. Remove the screws from the right
shield, and then carefully pull the shields away from
the frame.
Loosen, but do
not remove, the
three indicated
screws (A).
Insert the shaft
of a screwdriver
downward
between the
Idler Pulley (22)
and the pulley
(B). Pull the top
of the screw-
driver toward
the rear of the
exercise cycle
until the Belt
(28) is tight. Then, tighten the three screws.
Reattach the shields, and then reattach the pedals. To
attach the pedals, turn the right pedal clockwise and
turn the left pedal counterclockwise.
Leveling
Feet
28
A
B
22
MAINTENANCE AND TROUBLESHOOTING
