E-17
USB Cable Holder Installation
This holder prevents the USB cable from becoming disconnected due to vibration,
etc.
Place the PS-A unit face-down on a flat surface as shown below. Your PS-A
unit has two USB connectors.
• When using both USB connectors, be sure to first connect one USB cable to
the lower USB connector, then connect the second USB cable to the upper
USB connector.
• When using only one of the USB ports, be sure to use the lower USB connec-
tor. This allows you to securely clamp the USB cable in the cable clamp.
Upper USB Interface
Lower USB Interface
USB Cable
Clamp
Band
Bridge
Cable Collars
Clip
Clamp
[Attachment]
As shown below, insert the USB Cable Clamp’s band through the Bridge. Pass the
USB cables through the Cable Clamp’s band and securely tighten the clamp band
around the cables.
• Be sure the clamp is securely holding the USB cable’s plug and collar.
• Be sure the clamp is positioned as shown below, with the clamp pointing
upwards – not to the side. This is to keep the clamp from interfering with
nearby connectors and their cables.
[Removal]
To remove the clamp from the USB cables, push down on the clamp strap’s clip to
release it while pulling up on the clamp.
