Pro-face GP-4402WW, Руководство по оборудованию

Страница: 23 / 62

GP-4402WW/GP-4502WW Hardware Manual
23
The front face of the panel, installed in a solid panel, has been tested using conditions equivalent
to the standards shown in the specification.
El
ectric
a
l
Radiated radio frequency
electromagnetic field 10 V/m / 80 MHz...1 GHz, 3 V/m / 1.4 MHz...2 GHz, 1 V/m /
2 GHz...3 GHz, sinus amplitude modulated 80 % / 1 kHz and
internal clock frequency
Electrical fast transient EN/IEC 61131-2 zone B
2 kV power supply and 1 kV shielded cables
High energy surges IEC 61000 - 4 - 5
0.5 kV (Differential mode on power supply)
1 kV (Common mode on power supply)
Electrostatic discharge immunity EN/IEC 61131-2
4 kV contact, 8 kV air
CAUTION
EQUIPMENT DAMAGE

Ensure that the panel is not in permanent and direct contact with oils.

Do not expose the device to direct sunlight.
Failure to follow these instructions can result in injury or equipment damage.
NOTICE
STORAGE AND OPERATION OUTSIDE OF SPECIFICATIONS

Store this product in areas where temperatures are within the product’s specifications.

Do not restrict or block this product’s ventilation slots.
Failure to follow these instructions can result in equipment damage.
NOTICE
GASKET AGING

Inspect the gasket periodically as required by your operating environment to keep the initial IP
level.

Change the gasket at least once a year, or as soon as scratches or dirt become visible.
Failure to follow these instructions can result in equipment damage.
Specification Value
1
For in-rush current, the FWHM (full-width, half maximum) value is approximately 50

s (when exceeding
25 A).