Pro-face GLC2500-TC41-24V, Руководство пользователя

Страница: 9 / 14

-23-
Pin Arrangement Pin #
Signal
Name
Condition
1 FG Frame Ground
2 SD Send Data (RS-232C)
3 RD Receive Data (RS-232C)
4 RS Request to Send (RS-232C)
5 CS Clear to Send (RS-232C)
6 DR Data Set Ready (RS-232C)
7 SG Signal Ground
8 CD Carrier Detect (RS-232C)
9 TRMX Termination (RS-422)
10 RDA Receive Data A (RS-422)
11 SDA Send Data A (RS-422)
12 NC Not Connected (Reserved)
13 NC Not Connected (Reserved)
14 VCC 5V±5% Output 0.25A
15 SDB Send Data B (RS-422)
16 RDB Receive Data B (RS-422)
17 RI Ring Indicate (RS-232C)
18 CSB Clear to Send B (RS-422)
19 ERB Enable Receive B (RS-422)
20 ER Enable Receive (RS-232C)
21 CSA Clear to Send A (RS-422)
22 ERA Enable Receive A (RS-422)
23 NC Not Connected (Reserved)
24 NC Not Connected (Reserved)
25 NC Not Connected (Reserved)
„ „
„ „
„
Serial Interface
4 Interfaces
Recommended Connector : Dsub 25-pin plug XM2A-2501 <made by OMRON Corp.>
Recommended Cover :
Dsub 25-pin Cover XM2S-2511 <made by OMRON Corp.>
Recommended Screw : Jack Screw XM2Z-0071 <made by OMRON Corp.>
Recommended Cable : CO-MA-VV-SB5P x 28AWG <made by HITACHI Cable Ltd.>
• This GLC unit's serial port is not isolated. When the host (PLC) unit is
also not isolated, and to reduce the risk of damaging the RS-422 circuit,
be sure to connect the #7 SG (Signal Ground) terminal.
• Pin #14 (VCC) DC 5V Output is not protected. To prevent damage or unit
malfunction, use only the designated level of current.
• Inside the GLC unit, the SG (Signal Ground) and FG (Frame Ground)
terminals are connected to each other.
• When connecting an external device to the GLC with the SG terminal,
ensure that no short-circuit loop is created when you setup the system.
1
14
13
25
This interface is used to connect the GLC to the host (PLC), via an RS-232C
or RS-422 cable.The connector used is a socket-type connector.