8
Connecting the ST Power Cord
(1) Be sure that the ST's power cord is not
plugged in to the power supply.
(2) Remove the Terminal Strip's clear plastic
cover.
(3) Remove the screws from the two (2)
terminals (L,N) and FG (Frame Ground)
Terminal, position the Ring Terminals and
reattach the screws. (Check each wire to
make sure the connections are correct)
• The torque required to tighten these
screws are as follows:
Terminal Block: 0.5 to 0.6 N
•
m.
FG (Frame Ground) Terminal: 0.6 to
0.7 N
•
m.
(4) Reattach the Terminal Strip's clear
plastic cover.
2.
Wiring the DC type power supply
cable
Power Cord Specifications
Use copper conductors only.
Power Connector (Plug) Specifications
• The power connector (plug) is CA5-
DCCNL-01 made by Pro-face or
GMVSTBW2,5/3-STF-7,62 made by
Phoenix Contact.
When connecting the Power Cord, use the
following items when performing wiring.
(Items are made by Phoenix Contact.)
Power Cord
Diameter
0.75 to 2.5mm
2
(18 - 12 AWG)
Conductor
Type
Simple or Stranded Wire
*1
*1 If the Conductor’s end (individual) wires are
not twisted correctly, the end wires may either
short against each other, or against an
electrode.
Conductor
Length
DON’T
CONNECT
FG (Frame Ground) Terminal
7 mm
[0.28in]
+
24V
-
0V
FG
Grounding
Terminal
connected
to the ST
chassis
Recommended
Driver
SZF 1-0.6x3.5
(1204517)
Recommended
Pin Terminals
AI 0.75-8GY (3200519)
AI 1-8RD (3200030)
AI 1.5-8BK (3200043)
AI 2.5-8BU (3200522)
Recommended
Pin Terminal
Crimp Tool
CRIMPFOX ZA 3
(1201882)
Power Cord
Insertion holes
FG
+
-
