background image

Please read these instructions carefully before use and retain for future reference.

IMPORTANT SAFETY INFORMATION

2

• 

Check if the voltage indicated on the rating plate of the appliance corresponds to 

the local mains voltage before you connect the appliance.

• 

Use this heater only as instructed in this manual. Any other use not recommended 

by the manufacturer may cause fire, electric shock, or injury to persons.

• 

This appliance is designed for use outdoors only.  The mains plug must only be 

connected to an IP rated external socket or suitable extension lead connected to an 

internal mains supply connected to a 30mA differential circuit breaker.

• 

The mains supply must be grounded.

• 

A worn mains socket may result in over-heating of the plug and socket. If this 

occurs consult a qualified electrician.

• 

Arrange mains cord away from any traffic area and where it will not become a 

hazard to users and ensure that the supply cord is kept away from heat or sharp 

edges that could cause damage. 

• 

The heater must not be located immediately below an electrical socket-outlet.

• 

Do not use this heater with a timer or any device that switches the power on 

automatically, as a fire risk exists should the heater be covered or place incorrectly.

• 

In case of improper use, there is a risk of electrical shock and/or fire hazard. 

• 

Do not try to repair the appliance by yourself. Please contact with the service agent 

or a suitably qualified electrician for maintenance. 

• 

This appliance is not intended for use by persons (including children) with reduced 

physical, sensory or mental capabilities or lack of experience or knowledge. They 

should be given supervision and instruction in the use of the appliance by a person 

responsible for their safety. 

• 

The casing and the front grille of the appliance can become extremely hot during 

operation. To avoid burns, do not let bare skin touch hot surfaces. Use handles 

when moving this heater. 

• 

Extreme caution is necessary when used by or near children or vulnerable people.

• 

This heater is not intended for use near swimming pools, hot tubs and similar 

locations. Never locate the heater where it may fall into any water container.

• 

To prevent a possible fire or electric shock, do not block or allow foreign objects to 

enter any air intakes or ventilation slots in any manner.

WARNING:

 In order to avoid overheating, do not cover the heater.

• 

Do not use floor standing heaters on soft or uneven surfaces where instability may 

be caused. 

• 

Do not operate any heater with a damaged cord or plug or after the heater 

malfunctions, has been dropped or damaged in any manner. 

• 

Keep combustible materials such as furniture, pillows, bedding, papers, clothes and 

curtains at least 0.9m from the front of the heater. 

• 

Please ensure that in adverse weather conditions no combustible material obstruct 

or come into contact with the appliance. 

• 

Do not use in areas where gasoline, paint, or flammable liquids are used or stored. 

• 

Remove the plug from the power outlet and wait until the appliance is completely 

cooled off before cleaning or putting into storage.

• 

To disconnect heater you should turn the controls off then remove plug from outlet. 

• 

Always unplug heater when not in use. 

Содержание PEL01218









Отзывы: