Pro-Elec PEL00571, Инструкция по эксплуатации

Страница: 4 / 4

4
CLEANING & MAINTENANCE
• Before cleaning the appliance, follow the cool down process and disconnect it from
the mains power supply.
• For stubborn marks, wipe with a damp cloth and mild detergent if required, then
dry the heater with a clean cloth.
• Do not use any chemicals, abrasives or solvents that may damage the heater.
• Before storing the heater, allow it to cool down in a cool, dry environment.
• Cover the heater to prevent dust accumulating and store in a dry, ventilated area.
SPECIFICATION
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF
ELECTRICAL & ELECTRONIC EQUIPMENT
When this product has reached the end of its life it must be treated as Waste Electrical &
Electronics Equipment (WEEE). Any WEEE marked products must not be mixed with general
household waste, but kept separate for the treatment, recovery and recycling of the materials used.
Contact your local authority for details of recycling schemes in your area.
Made in China. PR2 9PP
Man Rev 2.1
As is typical for all portable heaters -
This product is only suitable for well insulated spaces or occasional use.
Model PEL00571 Heat Output
Rated Voltage 230VAC
Nominal heat output P
nom
3.0kW
Frequency 50Hz
Min heat output P
min
1.5kW
Rated Power 1.5-3.0kw
Max heat output P
max
3.0kW
Auxiliary electricity consumption
At nominal heat output el
max
3.0kW
At minimum heat output el
min
1.5kW
In standby mode el
sb
N/A
With mechanical thermostat room temperature control YES
IP Rating IP24
Gross/Net weight 6.2kg/5.5kg
Dimensions (mm) 360 x 320 x 425
• After use, turn the thermostat to the lowest position and turn the selector switch to
‘fan level’ and allow the appliance to cool down for two minutes.
• The product can be adjusted upwards to an angle of up to 10 degrees.
• The heater has a built-in anti-overturn switch, which will shut down the heater if it
is tipped over, beyond an angle of 50 degrees.
INSTRUCTIONS FOR USE
• Set all the controls to OFF position and insert the plug into a mains socket
• Rotate the thermostat knob clockwise to MAX position and switch the heater on.
• When your room reaches the desired temperature, slowly rotate the thermostat
control counter clockwise until the heater element switches off. The thermostat can
now be left at this setting. As soon as the room temperature has dropped below
the set temperature, the heater element will switch it self on automatically.
Note: When using the heater for the first time, you may notice a slight emission of
smoke and odour. This is quite normal and will stop after a short period of time.