Pro-Elec PEL00571, Инструкция по эксплуатации

Страница: 3 / 4

3
PRODUCT DESCRIPTION
1
2
3
4
5
6
7
8
9
1) Handle 4) Front Grille 7) Adjustment Knob
2) Power Switch 5) Support Frame 8) Rear Grille
3) Thermostat 6) Adjustment Plates 9) Motor
CONTROL PANEL
• The fan level can be set with the second dial at three
different levels:
- Fan only
- Fan with heating at half power
- Fan with heating at full power
• To set the temperature, turn the thermostat to 50%.
• When the temperature reaches the desired level, adjust the dial down to just
before the heater switches off.
• If the level is not reached, increase the thermostat gradually until the level is
reached.
• The thermostat will switch the heater on and off to maintain this temperature.
• The angle of the heater can be adjusted by loosening the knobs on the side of
the fan and by pushing the front or back of the heater to adjust the angle, to a
maximum of 14 degrees.
• Tighten the adjustment knobs when the angle required is reached.
• After use, turn the thermostat to the value setting and then select ‘Fan Only’ level
to allow the heater to cool down for two minutes.
FEATURES
• This electric fan heater incorporates a thermostat and an automatic reset cut-off.
Once the temperature falls, the heater will begin operating again.
• The thermostat senses the air inlet temperature and controls the room temperature
(0°C to 40°C adjustable).
• The manual reset cut-out controls the temperature of the air outlet. It will switch off
the heater in the event of overheating, in order to ensure safe use.
• The fan motor is not controlled by the thermostat.
• When the thermostat cuts off the heating element, the fan will continue to operate.