INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF
ELECTRICAL & ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste
Electrical & Electronic Equipment (WEEE). Any WEEE marked products
must not be mixed with general household waste, but kept separate for the
treatment, recovery and recycling of the materials used. Contact your local
authority for details of recycling schemes in your area.
Made in China. PR2 9PP
Man ReV.1.0
INSTRUCTIONS FOR USE
•
Before using the heater, make sure that it is on a flat and stable surface. Damage
may occur if it is placed on an incline or uneven surface.
•
Set all the controls to OFF position and insert the plug into a mains socket
•
Rotate the thermostat knob clockwise to MAX position and switch the heater on.
•
The power switch has three heat settings I, II and III, power on is indicated by a
LED.
•
When your room reaches the desired temperature, slowly rotate the thermostat
control counter clockwise until the pilot light goes out. The thermostat can now be
left at this setting. As soon as the room temperature has dropped below the set
temperature, the unit will switch it self on automatically until the set temperature
has been reached again. In this way the room temperature remains constant with
the most economical use of electricity.
•
If you want to change the room temperature setting, rotate the thermostat knob
clockwise to raise the temperature, or counter clockwise to lower it.
•
This heater includes an overheat protection system that shuts off the heater when
parts of the heater are getting excessively hot.
•
To completely shut the heater off, turn power switch to OFF (O) and remove the
plug from the mains socket.
•
If the heater is to remain unused for long periods, wind the cable around the cable
storage boss and store the heater in a clean dry place.
CLEANING AND MAINTENANCE
•
Always remove the plug from the mains socket and allow the radiator to cool down
before cleaning the heater.
•
Wipe the radiator with a soft damp (not wet) cloth.
•
Do not use any cleaning chemicals such as detergents and abrasives.
•
In case of malfunction or doubt, do not try to repair the radiator yourself, it may
result in a fire hazard or electric shock.
USING THE TIMER
•
Set the timer by adjusting the clock wheel so that the arrow points to the current
time.
•
Set the slide switch position to the clock setting.
•
Set the time periods required for heating by pushing the red teeth outwards.
•
Each tooth represents 15 minutes.
•
Pushing the teeth back to the centre will turn the heater off for that period. To run
the heater continuously set the slide switch to the I position.
