PRODUCT OVERVIEW
1. Carry Handle
2. Indicator Light
3. Power Switch
4. Adjustable Thermostat
5. Timer
6. Power Cord Storage
7. Fin Body
8. Castor
Models with built in timer
ASSEMBLY INSTRUCTIONS
•
The heater is packaged with the feet unattached. You must attach them before
operating the heater.
WARNING
: Do not operate without feet attached. Only operate the heater in an upright
position (feet on the bottom, controls on the top), any other position could create a
hazardous situation.
1. Place the radiator body upside-down on a scratch-free location, make sure it is
stable and will not fall.
2.
Remove the wing nuts from the U-bolt provided (see Fig 1), insert the U-shaped
bolt around the flange between first pair of fins (near the front cover) (see Fig 2).
3.
Insert the threaded ends of the U-bolt through the holes on the castor mounting
plate (see Fig 3).
4.
Screw the wing nuts back on to the U-bolt and tighten (see Fig 4).
5.
Repeat with the rear castor inserting the U-bolt between rearmost pair of fins
Note: do not over-tighten, as this may cause the damage of radiator flange.
6.
Unscrew the nut from the castor, and insert through the end hole in the mounting
plate and refit the nut.
7.
Repeat for all four castors then tighten the nuts.
