6
IMPORTANT NOTICE
The mounting brackets of the system may contain keyholes that are designed so that screws can be
started before putting the charger into place. If applicable, the keyhole locations vary depending on
which model you own.
Before making any connections, prepare batteries as follows:
(a) With caps securely in place, thoroughly clean the case and posts with a solution of baking soda
and water. Be careful not to allow any baking soda to get inside the case.
(b) All posts, terminals, and connectors should be cleaned to a shiny bright finish, using a wire brush
or sand paper. This should be done periodically to assure maximum conductivity between the
battery and the charger.
Each charge cable assembly is equipped with a temperature sensor located at the junction of each set of
ring terminals. Attempts to shorten the cables could partially disable the charger. Therefore, we
recommend that you do not make any adjustments without first consulting our technical support group
(615.471.5300
). Proper cable extensions may be purchased in 5’, 10’, and 15’ lengths. See picture
below.
To connect the charger to the battery (batteries), route your charge cables from the charger to the
batteries, being cautious to avoid sharp objects, and use the supplied wire ties to hold them securely and
neatly in place.
Securely attach each charge cable independently to one 12V battery by connecting the red (po)
lead ring terminal to the positive (+) battery post and the black (negative/-) lead ring terminal to the
negative (-) battery post. See picture below:
