PRM NEWAGE PRM125D, Руководство по ремонту

Страница: 5 / 23

4 - PRM125
FOREWORD
Provided it is correctly installed, aligned and maintained, the PRM125D Gearbox should have a long and trouble-free
life. This workshop manual contains important instructions to ensure that this is so, and it is of the utmost importance
that these are carefully followed. PRM Newage Ltd. can accept no responsibility under warranty or otherwise for any
loss or damage resulting from failure to observe these instructions.
To avoid prejudicing your rights under warranty, do not undertake any repair or other work on the Gearbox during the
warranty period without first contacting PRM Newage Ltd. or an authorised distributor/dealer for advice. In the event of
failure, you should do this via the engine distributor who supplied the Gearbox, or his local dealer; if this is not possible,
you should notify the local Newage distributor/dealer or PRM Newage Ltd. direct, quoting the serial number.
CLAIMS UNDER WARRANTY
Claims for replacement of parts under warranty must always be submitted with the Gearbox serial number to the
distributor who supplied the Gearbox; if this is not possible, application may be made to the nearest distributor, who
must, however, be advised of the supplier's name and address.
SERVICE PARTS
The comprehensive illustrated parts list gives full information and ordering procedure.
PRE-DELIVERY TEST
Before it leaves the factory, every Gearbox is subjected to a final test and inspection which includes the following:
1. Flush clean.
2. Pressurise the Case, and check for oil leaks.
3. Check drag torque in ahead, neutral and astern.
4. Run Gearbox in neutral, ahead and astern in load conditions.
5. Check force to engage and disengage ahead and astern Gear.
6. Check noise levels.
7. Check Output Nut torque.
8. Check Coupling concentricity.
IMPORTANT NOTICE: ONLY REMOVE BREATHER,
DIP STICK, OIL DRAIN PLUG OR OIL LEVEL PLUG
ONCE THE GEARBOX IS AT AMBIENT
TEMPERATURE. REMEMBER HOT OIL CAN CAUSE
BURNS – WORK SAFELY.