Moog Components Group Single Port GBE Media Converter Manual August 12, 2009
Page 5 of 7
functioning.
LED3
(Green/Green)
Dual LED, located on the right center of the board, labeled „COL/FIBR‟.
When „ON‟, the upper LED provides an indication that there is a GBE cable is attached to the
RJ-45 connector and there is an Ethernet device on the cable.
The lower LED will blink „OFF” to indicate that there is Ethernet activity (traffic) on the
cable.
Refer to the note in Section 1.3 above.
NOTE: THE ‘COL/FIBR’ LABEL IS INCORRECT ON THE REV A PCB VERSION.
FUSES:
There is one fuse for this board. All fuses are the self-resetting PTC type and should
quire replacement by the user.
F1
: 1.1 Amp PTC, DC input fuse at J2
SWITCHES:
There are no switches on this board.
TRIMPOTS:
There are no trimpots on this board.
CONNECTORS:
There are a total of 6 connectors on the board.
J1
:
2x4 pin external LED header
J1
LED Header
+3.3VDC
1 o o 2
LINK1000
GROUND
3 o o 4
LINK100
FIBER MEDIA SELECT
5 o o 6
LINK10
DUPLEX/COLLISION
7 o o 8
NO CONNECT
Note: these pins are not typically available to the user, contact Prizm
J2
:
2-pin Phoenix connector for DC power entry
J2
DC Power 2-pin Phoenix Connector
o 1
GROUND
o 2
+VDC INPUT
J3
: No connector on the board
J4
:
SFP optical module
J5
:
5-pin header for U3 programming – do not use
