GB12
Control Panel Description
The control panel is equipped with touch controls: to use them, just press the
corresponding symbol (a light touch is sufficient).
Switching on and adjusting cooking
zones
After positioning the pot on the chosen cooking zone, select the required power
level by turning the knob clockwise. Each cooking zone has different heat
settings, ranging from “1” (minimum power) to “9” (maximum power).
When a knob is set to a power setting between 1 and 9 the hob indicator light
switches on.
IMPORTANT:
at the position indicated by a “______” on the cooktop knobs
there is no function: the heating element is switched off.
IMPORTANT:
if no pot is placed on the hob or if the pot used is not suitable for an
induction hob, the cooking zone selected will switch off after 1 minute. To
reactivate it: place a pot that is suitable for the induction hob (see section “Before
use”) on the desired cooking zone, turn the knob to “0” and then select the
desired heat setting.
Switching off cooking zones
Turn the knob to “0”.
When all the knobs are set to “0” (or to the line “____”) the hob indicator light
switches off.
Care and maintenance
Clean the hob after each use in order to avoid damaging the surface and to
prevent the formation of baked-on deposits which are difficult to remove.
To clean the hob, proceed as follows:
1.
use a soft clean cloth, absorbent kitchen wipes or a proprietary cleaner for
glass ceramic hobs. Do not use abrasive sponges and/or metal scouring
pads;
2.
food spills should be cleaned off before they bake onto the glass ceramic
surface. Sugar and foods with a high sugar content damage the glass
ceramic surface and must be immediately removed using a scraper for glass;
3.
remove any stubborn food residues with a scraper or proprietary
detergents;
4.
salt, sugar and sand can scratch the glass ceramic hob: clean up any such
spills on the hob immediately.
Before contacting After-sales Service:
•
Read and follow the instructions given in the section “INSTRUCTIONS FOR
USE”.
•
Check that the electricity supply has not been shut off.
•
Clean the hob and dry it thoroughly.
•
Check that the knob is in the correct position: at position “0” or the levels
indicated by a continuous line, the cooking zones do not receive any power.
•
If no pot is placed on the hob or if the pot used is not suitable for an
induction hob, the cooking zone selected will switch off after 1 minute. To
reactivate it: place a pot that is suitable for the induction hob (see section
“Before use”) on the desired cooking zone, turn the knob to “0” and then
select the desired heat setting.
•
If the internal temperature of electronic parts is too high, the hob will
switch off automatically. Wait for the hob to cool down before using it
again. To resume operation, turn the knob to “0” and then to the desired
power level.
Before you call the After Sales Service:
•
try to solve the problem (see “TROUBLESHOOTING GUIDE”);
•
switch the appliance off, wait 30 seconds then switch it on again. to see if
the fault persists.
If after the above checks the fault persists, contact the nearest After-
sales Service.
Always provide:
•
a brief description of the fault;
•
the exact type and model of hob;
•
the service number (number after the word Service on the rating plate) is
located on the underside of the cooktop or on the warranty booklet;
•
your complete address and phone number.
If any repairs are required, please contact an authorized After-sales Service as
indicated in the warranty.
INSTRUCTIONS FOR USE
MAINTENANCE
WARNING
•
Do not use steam cleaners.
•
Before cleaning, leave the cooking
zones cool down
Power levels
No function
Cooking zone positioning
Cooktop operation
lamp
Level selector
TROUBLESHOOTING GUIDE
AFTER-SALES SERVICE
