Unroll your sail and lay it out as
shown. In addition to the sail,
you should have:
Connect the leading edge rods
for each wing at the ferrules. Be
sure the bridles are attached
beneath the rubber fittings as
shown.
Using your upper spreader as a
tool, tension the elastic at each
wingtip as shown.
Hook the elastic into the slot on
the side of the wingtip nock.
With your wingtips tensioned,
check that the sail is smooth
and wrinkle-free along the
leading edge. The tighter your
tip tension, the better.
Tension the sail by clipping the
standoffs into the lower
spreaders. Hang the kite from
the bridles to check that they
aren't tangled.
Insert the ends of the lower
spreaders into the center "T"
fitting.
ASSEMBLY
1
2
3
4
5
8
Clip the thin standoff rods into
the holes in the back edge of
the sail. Clip the long rods into
the inner holes, and the short
ones into the holes nearer the
wingtips.
6
Insert the upper and lower
spreaders all the way into the
leading edge fittings. Check
that the bridles are clear of
the fittings, and hold the
spreader rods close to the end
as shown so you don't slip
and puncture the sail.
7
Two long lower spreaders
One short upper spreader
Two short standoffs
Two long standoffs
