Printronix SL5000r MP, Руководство пользователя

Страница: 17 / 26

Inputs
17
Inputs
Reprint
When low going edge is detected, the printer reprints the last label printed
prior to receiving the signal. Only one label is reprinted. The signal must
toggle high then low again to reprint another label.
This feature requires 16MB DRAM printer memory to function.
Start Print
Signal polarity selectable via printer menu.
•
Active Low . The default. When low, the printer will print one label. If still
low at the end of the label, another label will be printed without delay. If
high, the printer will not print. If the signal goes high while the printer is
printing a label, printing will continue until the label has completed. The
printer will then stop and obey any other settings for end of label control
such as eject, feed a particular distance, etc.
•
Active High . Identical to Mode 1 except opposite polarity. A high input
will print one label, etc.
Feed
•
If low, will feed a blank label (or labels) until a high input is detected. A
high input stops the feeding of blank labels, and last blank label fed will
stop at top-of-form.
•
This signal has the lowest priority over other functions. If the printer is
printing, ODV is voiding, or there are any error conditions, the signal is
ignored.
NOTE: This signal also has lower priority than Start Print.
Pause
•
When a signal toggles from high to low, it causes the printer to go into
pause as if the PAUSE key were pressed.
•
If a signal goes low during an operation, it will be treated the same way as
if the PAUSE key were pressed, i.e., the label will finish if one was being
printed, etc.
•
This condition can only be reset by pressing the PAUSE key or by a
similar command from a host if you have created one.
•
The signal must toggle high then low again to achieve another valid
pause input.