Printronix L5535, Руководство по обслуживанию

Страница: 347 / 358

II–347
engine checker, II–338
MC board, I–207
peripheral equipment, I–260
cleaning unit, I–262
discharge lamp (PEL), I–261
main charger (MCH), I–260
precharger (PCH), I–260
separator claw assembly, I–262
support roller, I–265
transfer/separator charger (TCH/SCH),
I–260
photoreceptor
cleaning, I–96
disposal, I–259
installation, I–41
replacing, I–253
surface potential
control, II–151
control circuit, II–179
sensor (DSPS), I–323
sensor adjustment, I–215
Drum Motor Fail-complete stop (Error 18), I–146
E
Eject fanfold paper command, theory, II–167
Electrical
circuits, II–179
system, II–171
adjustments, I–227
configuration, II–171
Electronics initialization, theory, II–160
Elevator, transfer, motor, I–296
Engine checker, II–319
Basic menu, II–325
Basic Operation menu, II–340
connecting, II–320
control panel, II–323
Cut sheet Paper, II–341
Device Check menu, II–326
disconnecting, II–323
driving/stopping a device, II–335
Drum Motor, II–338
Eraser Lamp, II–338
Fanfold Paper, II–340
Feed Motor, II–339
Memory Operation menu, II–342
reading and changing data, II–343
reading device status, II–335
selecting a mode/item/device, II–334
Surface Potential, II–338
Toner Density, II–339
Tractor Motor, II–339
Engine CPU Fail (Errors 38 through 47), I–156
Engine, interconnection diagram, II–173
Eraser lamp
engine checker, II–338
MC board, I–208
ERROR
DC PROGRAM / NOT VALID, I–117
DRAM AT / ADDRESS xxxxxxxx, I–117
FLASH / DID NOT PROGRAM, I–118
FLASH / NOT DETECTED, I–118
FLASH TYPE / IS NOT SUPPORTED, I–118
NO DRAM / DETECTED, I–118
NVRAM / FAILURE, I–118
PROGRAM / NEEDS MORE DRAM, I–119
PROGRAM / NEEDS MORE FLASH, I–119
PROGRAM / NOT COMPATIBLE, I–119
PROGRAM / NOT VALID, I–119
SECURITY PAL / NOT DETECTED, I–119
SHORT AT / ADDRESS xxxx, I–119
WRITING / TO FLASH, I–119
WRONG / CHECKSUM, I–120
Error codes, I–101
01 - Front Cover Open, I–128
02 - Fan-fold Paper Empty
upon power-on, I–130
when loading/beginning print, I–131
03 - Paper Jam at Fuser, I–131
04 - Paper Jam at Exit
in transport section, I–132
05 - Paper Jam at Exit
in paper output section, I–133
07 - Scuff Lever Open
knob "C", I–134
08 - Cut-Sheet Path Open, I–134
09 - Transport Motor Fail (complete stop),
I–135
0A - Cutter Fail (front), I–136
0B - Cutter Fail (rear), I–136
0C - Transfer Platform Fail (upper), I–138
0D - Transfer Platform Fail (lower), I–138
11 - Paper Jam at Drum, I–140
12 - Paper Jam at Fuser, I–140
13 - Paper Jam at Exit (face up), I–141
13 - Paper Jam at Exit (facedown), I–141
14 - Tractor Speed Too High, I–142
15 - Tractor Speed Too Low, I–142
16 - Paper Jam at Entrance (A), I–144
17 - High Voltage Fail, I–144