V 4.0
8551327
4
For technical questions call 1-800-665-8685
Pneumatic Paint Can Shaker
5. Avoid unintentional starts. Be sure the switch is in the OFF position when not in
use and before connecting it to any power source.
AIR TOOL PRECAUTIONS
1. Extended exposure to air tool noise may cause hearing loss. Ear protection
gear can reduce or eliminate the noise level.
2. Inspect the tool’s air line for cracks, fraying or other faults before each use.
Discontinue use if the airline is damaged or hissing is heard from the airline or
connectors, while operating the tool. Replace the defective component/
air line.
3. Do not allow people, mobile equipment or vehicles to pass over the
unprotected air line. Position the airline away from high traffic areas, in a
reinforced conduit or place planks on both sides of the airline to create a
protective trench.
4. Prevent damage to the air line by observing the following:
a. Keep the air line behind the tool and out of the tool’s work path.
b. Keep the air line away from heat, oil, sharp edges or moving parts.
c. Do not wrap the air line around the tool as sharp edges may pierce or
crack the airline. Coil the airline when storing.
5. A damaged or disconnected air line under pressure may whip around and
inflict personal injury or damage the work area. Secure the compressor’s
airline to a fixed or permanent structure with clamps or cable ties.
6. Install an in-line shutoff valve or regulator to allow immediate control over the
air supply in an emergency, even if a hose is ruptured.
TOOL USE AND CARE
WARNING! Do not use the tool if the ON / OFF switch does not function properly.
Any tool that cannot be controlled with the ON / OFF switch is dangerous and must
be repaired.
1. Use the correct tool for the job. Maximize tool performance and safety by
using the tool for its intended task.
2. Do not modify this tool or use for a purpose for which it was not designed.
3. This tool / device was designed for a specific function.
Do Not:
a. Modify or alter the tool; all parts and accessories are designed with
built-in safety features that may be compromised if altered.
b. Use the tool in a way for which it was not designed.
4. Avoid unintentional starts. Be sure the switch is in the OFF position when not in
use and before connecting it to any power source.
5. Maintain the tool with care.
