Unpacking
When unpacking, check to make all parts listed on pages 8 to 10 is included. If any parts are missing or broken, please
call your local retailer.
Notes:
• Table Stand is specifically designed for use with this 10” Tile Saw and is not included. Stand is available for
purchase from your local retailer. And table stand is packed in an individual carton,
• If the stand is not to be used with the tile saw, the saw must be securely mounted onto a flat level surface capable of
supporting the weight of the tile saw in addition to the weight of all work pieces
Assembly
1.
Slide the water tank through the slot in the machine frame so that the entire tank rests inside the machine frame.
2.
Mount the motor to the machine frame by connecting the supporting frame to the machine frame at the point
shown in the assembly diagram on page 10. Secure using two bolts, elastic washers and big flat washers as
shown.
3.
Next, attach the blade guard to the motor using the locking knob and flat washer provided. Please note this
product does not include a blade. Please see the following section “changing/installing the blade,” for instruction
on how to properly install a new blade.
4.
Plug the pump into the back of the back of the motor and attach the pump to the water tack using the four suction
feet on the bottom of the pump.
5.
Slide the table holder through the middle of the rail over and fit the two inserts over the ends of the cover to
prevent the table holder from slipping out.
6.
Attach the rail and table assembly to created instep 5 to the frame using two sets of the bolts. Flat washers and
both washers as shown in the assembly diagrams.
7.
Before operating this tool, mount the table saw to the table stand by following the steps outlined in the assembly
and operating instructions for the table stand. IF the stand is not to be used with the tile saw the saw must be
securely mounted onto a flat, level surface capable of supporting the weight of the tile saw in addition to the
weight of tall work pieces.
Installing changing blade
1.
Be sure that power cord is unplugged from it power source.
2.
Loosen the locking knob located on the side of the blade guard and raise guard. Tighten in knob to lock the guard
in an “up” position.
3.
Depress the brake shaft button (see fig1 on page 7) while turning the blade (or spindle if you have not yet
installed a blade) with your hand until the shaft button depresses fully. This will prevent the spindle from spinning
and allow you to unscrew the nut and outer flange
4.
Slide the new blade over the spindle, and refasten the outer flange and nut, be sure to lighten the nut fully before
use.
5.
Lower the blade guard and tighten the locking knob.
Содержание 8130239
Страница 7: ...Figure 1 ...
Страница 8: ...Parts Diagram ...
