SEALING PROCEDURE:
Sprinkle 5 oz. (142 g) of
Gycor (HCS)
around the edge of
the ring weight. Drain the vat and re-circulate the short-
ening. This process should “seal” air leaks around the
ring.
CAUTION:
Use this procedure only when a leak
occurs and all shortening cannot be drained. Using
excess Gycor (HCS) can cause the machine to clog
during filtering of last vats. THIS SHOULD ONLY BE
AN INTERIM PROCEDURE UNTIL EQUIPMENT CAN
BE REPAIRED OR REPLACED.
ORDERING/SERVICE INFORMATION
1.
WHERE AND HOW TO ORDER
REPLACEMENT PARTS
To order replacement parts, look on the back of your
Prince Castle Price List for the name and phone
number of your local Prince Castle Service Center.
You may also call Prince Castle at 1-800-323-2930
(or fax us at 630-462-1460) for the name of your local
Service Center.
2. PARTS RETURNS
To return parts to your Service Center for credit, you
must obtain authorization from your Service Center.
iMPORTANT:
All warranty situations should be handled
by your center.
3. PRICES:
A. All prices are F.O.B. Prince Castle Service
Center or F.O.B. factory, Carol Stream, Illinois.
B. All prices are subject to change without notice.
These prices are exclusive of all sales taxes or any
special taxes which may be levied by federal, state,
or city governments.
OUTSIDE THE U.S.
Contact your kitchen equipment supplier or designated
repair facility for parts and service.
NON-SCHEDULED MAINTENANCE
IMPORTANT:
No user-serviceable parts are inside this
motor and pump assembly. This motor and pump
assembly must be serviced by a Prince Castle Autho-
rized Service Center. Failure to do so can void the
warranty.
10
TROUBLESHOOTING CHART
Shortening cannot be
Bowl not level (Can cause
See sealing procedures on page 11.
completely pumped out
“seal” to break).
Repair or replace wheels on filter machine.
(shortening covering
Filter paper clogged.
Machine must be broken down, cleaned,
surface of filter paper).
and set up again.
(cont.)
Too much
Gycor or Filter Aid
Must use recommended amounts to prevent
(HCS).
clogging.
Excessive food particles.
Skim vats more often and before filtering.
Shortening too cool.
Shortening must be at cooking temperature
prior to filtering.
Filter powder
Ring weight bent.
Replace ring weight.
pumped back into fryer.
Nick or debris on seal surface Replace bowl.
on bowl.
Screen assembly bent.
Replace screen assembly.
Filter paper torn.
Replace filter paper.
PROBABLE CAUSE
PROBLEM
CORRECTIVE ACTION
