2.LIGHTING BURNER
1. Check that the
gas control is
shut off, then turn
the gas cylinder
valve on in an
anti-clockwise
direction for one
full turn.
2. Take a lit match
or lighter and
position close
to the edge of
the burner that
is to be ignited,
slowly turn the
gas control in an
anti-clockwise
direction approximately ¼ of a turn.
3. If the burner does not ignite, turn the
gas control in the clockwise direction
to the “Off” position and allow the
residual gas to disperse before
attempting to reignite the burner.
3.ADJUSTING FLAME
1. Turn the gas
control in an
anti-clockwise
direction to
achieve a higher
flame and in
the clockwise
direction for a
lower flame.
4. TURNING THE APPLIANCE OFF
If the appliance is no longer to be used and to
reduce the risk of blocked gas jets caused by
excess gas being left in the hose, all remaining
gas must be expelled from the hose assembly.
1. With the flame
still operating,
turn the valve
on the gas
cylinder in
the clockwise
direction until
it is “Off”. Allow
the flame to
burn down then
extinguish once
all remaining gas
in the hose has
been used.
2. Turn the gas
controls on the
appliance
clockwise to the
“Off” position.
CARE INSTRUCTIONS
Your appliance is manufactured with a hard
wearing powder coated finish on the cabinet,
chrome plated burners, trivet and stainless
steel drip tray (if fitted) and is easy to clean.
Using warm soapy water with a mild detergent
wipe down all surfaces and areas of the
appliance, taking care not to allow water to
enter the burner outlets or aeration holes
located in the burner tube.
DO NOT submerge the appliance is a sink
or bowl.
DO NOT use abrasive cleaners or bleach.
