1.
STEAM IRONING
Use tap water with hardness below 6 German degrees (you may use
deionized water which is useful for the longevity of the ironing board)
Unscrew safety cap No.1 and fill it with water, approximately 2,2 liters.
Put the plug in a socket.
Press switches No.2 for steam production & No.3 for the steam iron
function. The lights of the switches must be on, to indicate that the
boiler and the iron are functioning.
Select the desired temperature for the iron by turning the iron’s
temperature knob (No.6) clockwise. When using steam, temperatures
from the indication (●●) and above must be selected. The higher this
indication is, by turning the knob clockwise, the drier the steam is.
It takes about 10-15 minutes for the ironing board to reach the selected
steam pressure.
When light No.5 “steam ready” is on the system is ready to be used.
Place the fabric you wish to iron, press the steam iron button (No.8) to
supply steam to the steam iron.
The amount of the steam supply can be adjusted by turning the steam
knob (No.10) until you reach the desired amount of steam.
When the light “without water” No.4 is on it means that there is no
water in the boiler. Turn off the system by switching of switches No.2 &
No.3.
Remove all remaining steam by slightly unscrewing safety cap No.1 or by
repeatedly pressing the steam iron button, having the steam production
switch No.2 off. Wait until there is no steam coming out of the safety
cap. Completely unscrew the water safety cap and fill the system with
water.
2.
IRONING WITHOUT STEAM
Plug in the main device, press the steam iron switch (No.3)
Select the desired temperature by adjusting the thermostat button (No.6)
Wait until the steam iron reaches the desired temperature.
NOTES
Never use salt removal liquids that have not been approved by the
manufacturer.
Keep the bottom plate of the steam iron clean. Clean the bottom
plate with a damp cloth when the iron is cold or use special wax and
cleaning cream appropriate for iron bottom plates.
After use, place the steam iron on its base. Make sure that the
bottom is cold and there is no water dripping.
