Instruction Manual ECO FL
7
Assembly the base of button pedal (B) on top of it, by tightening all the screws.
Turn the ironing table, the right side up.
Afterwards put the ironing surface(C) of top of the stand and tighten all the screws once
again.
5.
Electrical Connection
For the electrical connection and above all for the power supply, please follow carefully the
instructions of the wiring diagram (enclosed) as well the warning signs symbols attached on the
machine. In case you have purchased a single phase machine 230V, connect the machine to the
power into the socket 230V/16A. The connection should be done with 3-phase 3Χ1,5 mm (1 phase,
1 neutral, 1 grounded). The power should be provided with a fuse 10Α.
CAUTION! For your own safety, pay attention to all the warning labels (yellow colored) that are
placed on the machine. The manufacturer bears no liability for any damages or accidents due to
faulty supplying network or to not specified personnel.
6.
Activation Instructions
Picture 3: Images of Switches placed on Eco FL
Switch on the main switch (No 1)
Switch on the thermostat knob (No 3) at a temperature of 110°C during the winter and at 90°C
during the summer.
Whenever you want to use suction/vacuum, just press the food pedal with your foot.
Adjust the steam quantity of your steam generator in proportion to the suction capacity used
on the ironing table, in order to avoid steam liquidation on the working surface.
Especially during the wintertime when the environment’s temperature is low and the
environment’s humidity is elevated.
The delicate fabrics require a small quantity of steam, while the rougher fabrics require large
quantity of steam.
The ironing buck’s heating is activated when you press the switch (No 2) to position I.
