It's recommended that the device is in a clear line of sight to a wireless access point. If the location is NOT in a clear
line of sight to a wireless access point, its LCD screen must be above the unit it's being mounted to.
Wireless signal strength of -60db or better at the mounting location. It's recommended to measure the strength with
a Wi-Fi analyzer app on a mobile phone.
• PoE/Ethernet use
An open, active network port in close proximity to the mounting location.
• AC power
Outlet within 5 ft. (1.5 m) from its mounting location. Devices using AC or PoE power can also use battery power as a
backup power source in the event of a power loss. During battery backup, the device operates on battery power and
continues to log and transmit readings until the primary power source is restored.
CAUTION
The device is shock and vibration resistant; however, be careful not to drop or install the device in a
location where it could be exposed to excessive vibration.
Step 1: Verify sensor configuration
Prior to installation, a sensor device must be configured for use with OneVue. A sensor is either configured prior to
shipment through Device Preconfiguration or onsite using the OWDC app.
• Device Preconfiguration completed: white label with configured settings is affixed to the backside of the sensor.
Sensor has been configured with network settings allowing its connection to OneVue and also added to OneVue.
Proceed to next install step.
• OWDC onsite configuration required: Sensor shipped with factory default settings and is not added to OneVue.
You must configure the sensor now using the OWDC app.
Step 2: Insert sensor batteries and turn on battery power
1. Remove device cover; simultaneously press the two tabs located on the top side of the device (A).
2. Insert the 3.0v Primex Lithium/Iron Disulfide Battery Pack or two 1.5v Lithium AA batteries. Follow the symbols
showing the correct way to position the positive (+) and negative (-) ends of the battery pack.
3. Located to the lower-right of the battery compartment, set the battery on/off switch to the Up (On) position (B).
4. Replace the device cover.
Page 11
