
ENGLISH
13
5
MAINTENANCE
5.1
Electrical and mechanical irregularities
Before calling the Technical Service Centre, check the
following:
That power is supplied to the machine.
The condition of the fuses.
That the voltage is correct for the machine.
If the washing machine fails to get the required
level of water, check:
The water mains tap is open.
The water inlet filter is not blocked.
That the water pressure is between 2 and 4 kg/cm 28
(28 and 56 psi).
If the washing machine vibrates excessively,
check:
None of the panel screws is loose.
If a power cut occurs, check:
The tub is drained and the door is blocked. If you want
to take the clothes out of the washing machine, unlock
the door by pulling down the belt located behind the
front panel.
5.2
Error messages
On the washing machine screen, warning or fault
messages may be displayed during or after the
execution of a wash programme. Except in the event
of a power cut, the washing machine will be paused
(drain pipe valve off, motor off, etc.), awaiting user
action.
Message
Possible causes
Action
PWR FAUL
UAIT
This message appears on recovering the power after having been cut-off.
If the power cut occurs during the spin cycle, the message "WAIT" is
displayed. For safety reasons, wait approximately 1.5 minutes without
pressing anything until "PWR FAULT" is displayed.
Press START: the programme continues to
operate in the same phase as before the
power cut.
Press EXPRESS: the programme ends.
E2
FAULT LOCK
This message appears when it is detected that the door can not be unlocked
at the end of the programme or that it has unlocked during the programme
Press ESC: the programme ends.
E3
FAULT DRAIN PIPE
This message is displayed when, in spite of deactivating the emptying valve
output, the water level inside the drum has not decreased for a pre-
established period of time.
Press START: the programme continues.
Press EXPRESS: the programme ends.
E4
FAULT WATER INLET
This message appears when, in spite of activating the corresponding
solenoid valves' outputs, the water level inside the tub has not increased
during a certain pre-established period of time.
Press START: the programme continues.
Press EXPRESS: the programme ends.
E5
HEATING FAULT
This message is shown when, in spite of activating the heating output, the
water temperature has not increased for a certain pre-established period of
time.
Press START: the programme continues.
Press EXPRESS: the programme ends.
E6
MAX. TEMP
This message is displayed when the water temperature has exceeded 95 ºC.
Press START: the programme continues.
Press EXPRESS: the programme ends.
E7
THERMOSTAT OPEN
This message appears when the water exceeds 95 ºC
Press START: the programme continues.
Press EXPRESS: the programme ends.
E9
MOTOR HEATING
This message appears when the thermal protection of the washing
machine's motor is detected to have not been activated.
Press START: the programme continues.
Press EXPRESS: the programme ends.
E10
UNBALANCE
This message appears when the final spin activates the unbalance micro
three times.
Press EXPRESS: the programme ends.
E11
CLOTHES HOT
This message is displayed when a programme execution finishes but the
water temperature inside the tub exceeds 50 ºC.
Press EXPRESS: the programme ends.
E12
WATER IN TUB
This message is displayed when a programme execution is finished but there
is still water inside the tub. The door can not be opened until the water is
drained from the tub.
Press EXPRESS: the programme ends.
Содержание DHS-10
Страница 4: ...B A C H I F G...
Страница 76: ...4 2 1 2 3 4 2 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20...
Страница 78: ...6 4 12 1...