Operating the PRIMEDIC
™ DefiMonitor XD
54 / 116
DefiMonitor XD 21324 / GB / K05
METRAX GmbH
7.7
Operating the printer
Note
The printer can only be operated or used in manual mode.
7.7.1
Log of the ECG signal
The PRIMEDIC™ DefiMonitor XD is equipped with a high
-resolution printer. ECG printout of 3
to 6 channels simultaneously is possible. Printing speeds of 25 and 50 mm/s can be selected.
The online print function for logging the ECG graph during monitoring is activated by pressing
the printer On/Off button.
Pressing the printer On/Off button again stops the log printout. ECG printout is made with the
parameters selected in the setup menu. The following settings can be selected:
Printing parameter
Meaning
1 channel print
prints the upper ECG channel displayed on the monitor. If SpO
2
measurement is active, the SpO
2
pulse graph is also displayed.
3 channel print
Prints 2 ECG ch 1 channel SpO
2
simultaneously,
depending on which monitoring is displayed.
6 channel print
Prints the maximum possible number of derivations I, II, III, aVR,
aVL, aVF simultaneously, depending on the electrodes
attached, with a maximum of 3 derivations, each 5 seconds
before and 5 seconds after pressing the button.
25 mm/s - printer speed
Printout is produced at 25 mm/s.
50 mm/s - printer speed
Printout is produced at 50 mm/s.
The following relevant parameters are printed out in a header:
•
Date, time
•
Speed
•
Scale
•
Heart rate
•
Energy (Joule)
•
Mode
•
SpO
2
value (only on models XD3, XD30, XD300 and XD330)
There is a time lag of 7 seconds between the monitor display and the printout, i.e. events
which occurred before activation of the printout function can be displayed. If the printout is
stopped, printout also ends with data recorded 7 seconds previously.
