Using the freezer
Caution: Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the heat that is generated during opera-
tion can dissipate. Ensure that the ventilation slots are not covered. Make sure that the device is
sufiiciently far away from walls and other objects so that the air can circulate.
* Place the Freezer on a solid ground.
Place the freezer as shown. If you operate the box in a different position it can be damaged.
Notice: Danger from excessively low temperature!
Ensure that the only those objects are placed in the cooler that are intended to be cooled at the
selected temperature.
* Press the "ON/OFF" button for between one and two seconds.
* The LED lights up
* The display switches on and shows the current cooling temperature.
Note: The temperature displayed is that of the middle of the large interior compartment.
Note: When operating with the battery, the display switches off automatically if the battery voltage
is low. The LED flashes orange.
Latching the cooler lid
* Close the lid.
* Press the latch down, until it latches in place audibly.
Setting the temperature
* Press the "SET" button once.
* Use the “UP + and “DOWN - buttons to select the cooling temperature.
The cooling temperature appears in the display for a few seconds. The display flashes several
times then the current temperature is displayed again.
Using the emergency switch
The emergency switch is located below the control panel. For normal operation the switch is in the
“NORMAL USE" position.
lf an electronic control failure occurs, slide the switch to “EMERGENCY OVERRIDE" position
Note: If the switch is in the “EMERGENCY OVERRIDE” position, the cooler freezes with full cooling
capacity.
Switching off the Freezer
* Empty the Freezer.
* Switch the Freezer off.
* Pull out the connection cable.
lf you do not want to use the freezer for a longer period of time:
Leave the cover slightly open. This prevents odour build-up.
8
