11
10
OPERATION
LOADING PLASTIC CAPS
LOADING INSTRUCTIONS
1. Disconnect tool from air supply
using quick-connect coupling.
2. Open loading tower door by
pulling follower handle all the
way back, then out and away
from magazine.
3.
Laser weld caps:
Load two complete strips of
GripRite™ plastic caps into
tower. “UP” side of caps face
out. Top of cap stack must fit
below rim inside tower.
Skip to step 5.
4a.
String/adhesive caps:
Hang tool on belt using belt
hook. Load one complete strip
of GripRite™ plastic caps into
tower. Top of cap stack must
fit below rim inside tower.
4b. Hold cap stack down, and pull
plastic string completely free of
stack using other hand. Dis-
card string. Lift tool off belt.
OPERATION
LOADING FASTENERS
LOADING INSTRUCTIONS
1. Disconnect tool from air supply
using quick-connect coupling.
2. Depress magazine latch, and
slide magazine cover open.
3. Place one strip of GripRite™
GRCP5822 staples into
magazine.
4. Before closing magazine,
check cap driver hook position
for correct alignment with
recess on cap cylinder bolt,
and reposition hook if neces-
sary. See alignment label on
side of cap tower.
5. Slide magazine cover closed.
Magazine must click into
latched position.
6. Load plastic caps as shown on
next page.
A fastener can be driven unintentionally if the trigger and safety bracket
are activated at the same time. Always disconnect tool from air supply
before loading fasteners or plastic caps, or performing any service on
tool. Keep finger off trigger until ready to drive a fastener.
DANGER
