5
EvoLution Series
Warning
To prevent serious injury, electrical shock or fire:
•
Do not operate with the bottom plate removed. Keep away from rain and moisture.
•
Disconnect the ac mains cable before changing fuses and/or tubes.
•
Do not replace fuses with any fuse other than the same type and rating as used by the factory.
•
Do not replace tubes without reading instructions.
•
Do not replace fuses or tubes if you have any doubt about your ability to do so.
•
We accept no responsibility for any personal or material damage due to incompetent use or users.
Package
Contents
EVO Tube Integrated Amplifier
1 piece
EVO Remote Control
1 piece
Power Cord
1 piece
This Owner's Manual
1 piece
White Gloves
1 pair
Tube Complement
See specification pages
Spare Mains Littelfuse Model 213 fuse
1 piece
Spare Adaptive Auto Bias Littelfuse Model 213 fuse
1 piece
Initial
Setup
•
Don't wear a watch or rings and carefully remove the EVO Tube Integrated Amplifier from its
packaging. Once the plastic bag has been removed, use the white gloves provided to prevent
fingerprint smudges.
•
Remove the tube cage by carefully pulling it up and away from the amplifier.
•
Remove the protective foam surrounding the tubes.
•
Tubes are already installed.
•
Check that each tube is firmly and straightly seated in its socket. Use gloves provided.
•
Replace cage back in its place if desired.
•
Check to see the power switch is off (down) and the bias-selector switch is in the correct position.
•
Connect each source to the corresponding plugs.
•
Connect your speaker wires, positive to positive, negative to negative. This unit is non-inverting.
•
Plug the power cord into the amplifier, then into the wall socket.
•
Switch sources on and then switch the amplifier on.
•
The tubes will be warmed up and ready to use in about 60 seconds.
