Primal RC QICKSILVER, Инструкция по эксплуатации

Страница: 5 / 30

4
1/5 SCALE ELECTRIC DRAGSTER
Steering Wheel
Servo Sub-Trim
To be used for centering
the steering and throttle.
Model Select
Allows you to store and retrieve
programming Data for any
model 0 through 9.
Programming a receiver to
recognize the code of only
one specific transmitter.
Selecting menus and
programming the
transmitter.
Steering Dual Rate
Adjustment the throttle
and steering when it is
reverse.
To be used to adjust
steering servo throw.
End point adjustments allow you to
set the limits of all channels.
To be used to adjust steering
and throttle channel control
exponential.
Exponential
To be used for centering
the steering and throttle.
Servo Trim Anti-Lock Braking System
Primarily used on gasoline or glow
models that feature a throttle servo.
Model naming
Allows you to name each of the
10 different models.
Binding
Fail-safe setup
Before beginning the binding process, connect the switch harness, servos, and the receiver battery
to your MR-3D receiver. Make sure that both the transmitter and the receiver are turned OFF.
1. Turn the transmitter ON.
2.
Press and hold the receiver setup button, then turn the power switch on the
ON position. The receiver LED will flash quickly. Release the setup button
after 1 second.
3.Press and hold the binding button on the transmitter for 1 second until the
LED on the receiver is continuously lit.
1. Move the steering wheel or throttle trigger to the position where you want
the servo to move, press and hold the receiver setup button for 2 second
until the red LED on the receiver flash slowly, then press and hold the
receiver setup button again within 5 seconds until the receiver LED is
continuously lit, that's mean the F/S function has been correctly set.
2.Verify if the failsafe function has been correctly set. Turn off the
transmitter, then check if the servos moves to the position that you set.
Attention Note Direction
Do not mix batteries of different ages or types.
Bind Switch
Throttle Trim
3CH Switch
Power Switch
Steering Trim
Steering Dual Rate
Throttle Trigger
To be used for throttle operation.
Forward
Stop(Neutral)
Brake / Reverse
Straight (Neutral)
Left turn Right turn
Antenna
Built-in
Radio Function & Operations
To be used for centering
the steering.
To be used to adjust steering
servo throw.
ON OFF
L R
F
DEC
INC
B
To be used for centering
the throttle.
This switch is used for
optional parts.
Programming End Point / EPA Reverse Switch
Programming Window
Battery Level Indicator
Exchange Batteries
Battery/Switch Harness
Setup button
Antenna Wire
Receiver
Auxiliary(Channel 3)
Throttle(Channel 2)
Steering(Channel 1)
When the battery level indicator(LED)
blinks in red, replace the batteries with
new ones immediately.
Good Batteries
Low Batteries
(Light Blinks)
Voltage Monitor
S