www.primacoustic.com
Set the 48” back section onto the top assembly
being careful to line up the cam-pins and dowels.
Tighten all cams snugly using a Phillips screwdriver.
Set the bottom section onto the back section and
tighten the cams.
Rotate the frame so it is up-side-right.
Attach the 48” sides being careful to line up the
cam-pins and dowels. Tighten the cams.
5
6
Set the two panel stops on their edge with the four
small pilot holes facing up. Lay the vinyl material on
top of the panel stops.
7
Set the vinyl barrier and panel stop assembly
into the frame. Attach the panel stops using eight
medium Phillips screws into the pre-drilled hole
locations on the inside of the 48” side sections.
8
Push the Broadway acoustic panel into the front
of the frame assembly. The panel should fit
snugly inside the frame. Do not force the panel
into place.
Fasten the Broadway panel with two Phillips
pan-head screws through the pre-drilled holes
in the top section. This will prevent accidental
dislodgment of the panel.
Line up the edges flush and square. Drive eight
short Phillips pan-head screws through the vinyl
into the small pilot holes. Avoid stretching the vinyl
between screws. It should lay flat and limp.
TOP
BOTTOM
TOP
BOTTOM
LEFT
RIGHT
