www.primacoustic.com
Push two wooden dowels into each 48” side section.
1
With a Phillips head screwdriver, screw ten cam-pins into
the small pre-drilled holes on the top section and two into
the bottom section as indicated below.
2
3
4
Push four cam-locks into the 48” back section.
Ensure the open side of the cam-lock (marked with
an arrow head on the cam) is facing toward the
edge so it can mate with the cam-pin.
BACK SECTION
Push the beveled stretchers and support blocks onto the
cam-pins and dowels. Note the orientation of the small pilot
holes. These need to line up so the stretcher and support
block can be screwed together.
Screw four cam-pins into each 48” side section.
LEFT
LEFT
RIGHT
RIGHT
BOTTOM
TOP
BOTTOM
TOP
Place the top and bottom sections on the floor with
the pre-drilled holes facing up. Push four cam-locks
into each top and bottom section. Ensure the open
side of the cam-lock (marked with an arrow head on
the cam) is facing toward the edge so it can mate with
the cam-pin.
Push nine wooden dowels into the top section and
one into the bottom section as indicated below. Tap
lightly with hammer if necessary.
BOTTOM
TOP
BEVELED STRETCHERS
Push three cam-locks into each beveled stretcher.
Note the small pilot hole drilled in the edge of each
beveled stretcher. These will be used in the next
step.
Pilot
Holes
Push one cam-lock into each support block. Note
the small pilot hole on the top of each block. These
will be used in the next step.
SUPPORT BLOCKS
Pilot
Hole
Pilot
Hole
TOP
Pilot Holes
TOP
TOP
Pilot Holes
Tighten all cams snugly using a Phillips screwdriver.
Drive a medium Phillips head screw through the pilot holes on
each support block and beveled stretcher.
