www.primacoustic.com
Place the two 48” side sections on the floor with the
pre-drilled holes facing up. For each side section
push eight wooden dowels into the pre-drilled holes.
Connect the 23” top and bottom sections to a 48”
side section.
Note the 23” top section has small
piolet holes drilled along the front edge.
Use a
Phillips screwdriver to tighten the cams snuggly.
If the cam-locks won’t tighten ensure the arrow
head is facing outward so the cam-pins line up with
the cam-locks.
Set the cross support with the beveled edge onto the
wooden dowels near the top section. Be sure that the
beveled edge is facing inward and toward the bottom
section (see diagram). The beveled cross support is
used to wall mount the completed FullTrap.
Set the cross support with the square edge onto the
wooden dowels near the bottom section.
FRAME ASSEMBLY INSTRUCTIONS
Set the other 48” side section onto the frame
assembly being carefull to line up the cam-pins
and dowles. Tighten all cams snuggly using a
Phillips screwdriver.
Lay the completed frame down so the front is
facing up.
1
Place the two 23” top and bottom sections on the floor
with the pre-drilled holes facing up. Push four cam-
locks into the pre-drilled cavities on the 23” top and
bottom sections. Ensure the open side of the cam-
lock, marked with an arrow head, is facing toward the
edge so it can mate with the cam-pin.
2
3
4
FRONT
Beveled Edge
TO
P
BOTT
OM
For each side section thread four cam-pins into the
holes at the ends as shown.
TO
P
BOTT
OM
Piolet Holes
Locking Cams
