www.primacoustic.com
With the frame assembly lying on it’s back, set
the vinyl barrier assembly into the frame with the
panel stops facing upward (diagram).
Using eight (8) medium Phillips screws, attach
panel stops into the pre-drilled hole locations on
the inside of the 48” side sections (diagram).
VINYL BARRIER ASSEMBLY
5
6
Set two panel stops with the four small piolet
holes facing up, and larger pre-drilled holes facing
sideways. Lay the vinyl material on top of the panel
stops. Line up the edges flush and keep the vinyl
material square with the panels stops (diagram).
7
Lower in the Broadway fiberglass panel with the
fabric covering facing outward. The panel should
fit snugly inside the frame. Do not force the panel
into place.
8
Fasten the Broadway fiberglass panel at the top
end with two (2) Philips pan-head screws through
the pre-drilled holes in the 23” top section. This
will prevent the panel from becoming accidentally
dislodged.
Using eight (8) short Phillips pan-head screws
fasten the vinyl material to the panel stops.
Screw through the vinyl into the small piolet holes
(diagram). Avoid stretching the vinyl between
scews. It should lay flat and limp between screws.
