general installation instructions part 3 of 6
Follow all local and national electrical codes.
For assistance please call Prima Customer Ser
vice at 562-407-3079
IMPORTANT Please read these instructions prior to installation. Refer to the Prima catalog for proper lamp type and maximum wa
atest updates on
which lamps we support and proper usage. Prima low voltage transformers must be used with all Prima Lighting product installations. All warranties
are void if Prima transformers are not used. Prima’s catalogs provide general information and suggestions for proper dimmer usage. Please consult
improper
s prior to installation.
Support points are required along the FIT System track run at 4ft maximum intervals. When using connectors, supports must be installed on the connector
or within 6” of the connector. Additional supports may be required when using certain glass pendants. It is strongly recommended that gloves are used when
handling the FIT II System track. Oils and dirt from fingers can sometimes permanently mark the finish. Track should be cleaned with a damp cloth and thoroughly
dried before fixture installation.
(22-79131)
for end mounting point
Mounting
screws
Anchors
E
Track Support End Mount
Insert the Track Support End Mount to the
end of the track, and tightened the screw
with a screwdriver.
Insert the screw anchor, and tighten the screw
Be sure that the items indicated below are included in the package. Insert the Track Support End Mount to the end of the track, and tighten
it with a screw driver. Do both ends before mounting it on the ceiling. Mount screw anchor at the desired place, and use a mounting screw
to tighten it and cover the screw with the support cap.
Support Cap
E1
E2
E3
13615 Marquardt Ave. Santa Fe Springs, CA 90670
Ph. 562-407-3079 . Fx. 562-407-3069
www.primalighting.com
E
Be sure that the items indicated below are included in the package. Mount screw anchors in the mounting surface so that they align with
the holes in the mounting disk. Secure the mounting disk to the mounting surface with the included screws. Secure the track with the
locking knob. Insert the knob into the large hole on the side of the track bracket. Rotate the track locking knob 90º clockwise to lock the track.
Insert the track into the
track bracket
90º clockwise
Insert locking knob
Tighten inner knob
(22-65240 ~ 22-65248)
F
Use 22-79140 supporting clip for surface mount option.
WOOD CEILING ONLY.
After rotation,
adapter rests
inside track slot.
Ensure that there is
no gap between
the knurled knobs
before installation.
Apply pressure and
rotate 90º clockwise
Rotate knurled
locking ring
clockwise to
secure the adapter.
There should now
be a gap between
the two knobs.
F1
F2
F3
F4
F5
22-79140
*Caution:
Do not break the insulator inside
the chamber while using the
screw-in function. Broken insulator
will cause short of circuit.
Follow all local and national electrical codes.
For assistance please call Prima Customer Ser
vice at 562-407-3079
REV.
082217
WARNING: DO NOT ATTACH METAL CLIP TO ANY METAL CEILING, T-BAR, OR TRUSS
