3/5
INSTALLATION (ACCESSORIES NO INCLUDED):
1. FLANGE
•
Manufacture the mould with the iron cable or bar according to its
design.
•
Use the flanges to secure the luminous thread inside the cable.
•
It is perfect for Artwork and lighting of buildings.
2. STEEL MESH
•
Firstly make the design in its current size on paper.
•
Place the steel mesh over the design, fix the luminous thread on the mesh
with flanges according to its drawing.
•
It is perfect for Artwork.
3. FIXING CLIP
•
Set the fixing clip with ropes in wooden surfaces, with glue or double-
face adhesive tape, according to its design.
•
To make square or rectangular figures, use the appropriate fixing clip
and set it with ropes.
•
You can use it on wood surfaces, metal, etc It is perfect for great lighting
proyects.
4. CABLE CONDUIT
•
Set the cable conduit on a glass surface with the double-face cap or tie
it on wood surfaces.
• Push the luminous thread in the conduit.
•
It is perfect for right-line decoration.
5. SUCTION PADS
•
Fix the suction pads on the glass surface or metal with glue.
•
Use the flanges to fix the luminous thread to the suction pad.
•
It is suitable to glass or metal surfaces.
1
2
3
5
4
HOW TO CONNECT THE POWER CABLE
1.
Make sure that the luminous thread, which is going to be manipulated, is
not connected to any power supplier.
2.
Enter the connector with the pin male in the luminous thread in its right
position.
3.
Place the heat shrink tube over the luminous thread.
4.
Enter the other luminous thread in the connector, Make sure that the
connector has fixed in the right position inside the luminous thread.
5.
Once both of there are right fixed, apply some heat if you had used a
shrink tube with silicone.
6. The connectors and the joints cope with a limit of pressure.
plug
shrink tube